2019-12-03, 06:06 PM
Hi All,
I'm syncing up a commentary track to a blu ray and the volume is very low on it so I was just going to normalise it in sound forge.
However when looking at it, the audio goes further below the middle line than it goes above the middle line, see below:
https://www.mediafire.com/view/jzuqo1s3j...s.PNG/file
Not sure what causes this and if anything should be done to correct it? After normalising it looks like this:
https://www.mediafire.com/view/2dn2rrlck...p.PNG/file
It sounds a lot better than it was so I could just go with it. Any other suggestions? I didn't capture the LD myself.
Thanks
I'm syncing up a commentary track to a blu ray and the volume is very low on it so I was just going to normalise it in sound forge.
However when looking at it, the audio goes further below the middle line than it goes above the middle line, see below:
https://www.mediafire.com/view/jzuqo1s3j...s.PNG/file
Not sure what causes this and if anything should be done to correct it? After normalising it looks like this:
https://www.mediafire.com/view/2dn2rrlck...p.PNG/file
It sounds a lot better than it was so I could just go with it. Any other suggestions? I didn't capture the LD myself.
Thanks